Saa cowboy holsters

[blue62]

A set of cowboy action holsters to fit 5 1/2" saa.

Two layers herman oak 6/7oz,  finished with a coat of neatsfoot oil and tancote.

[AzShooter]

Very nice work.  

[blue62]

Thank you!

[JWheeler331]

Nice job. 

[Josh Ashman]

Outstanding job Blue62! Thanks for sharing! 

All the best, Josh

[blue62]

Thanks!

[1961Mike]

Hi Blue62

Nice job.  How did you get the neatsfoot oil so even?  I just did a belt with edge stamping instead of a stamped center and clear edge.  The stamps held a lot more oil than the clear areas.  In my case it won't matter because I'm putting on a coat of Skidmore's or two next.

Thanks

Mike

[blue62]

On 11/12/2020 at 11:14 AM, 1961Mike said:

Hi Blue62

Nice job.  How did you get the neatsfoot oil so even?  I just did a belt with edge stamping instead of a stamped center and clear edge.  The stamps held a lot more oil than the clear areas.  In my case it won't matter because I'm putting on a coat of Skidmore's or two next.

Thanks

Mike

Light coats, keep the oil warm, and one of the bigger things, if your leather is on the softer side it will take oil faster, any kind of stamping will also take oil quicker, so light coats and set someplace warm to let the oil even out.

[noobleather]

Great stamping work! Nice and clean looking

[1961Mike]

Hi, Thanks, the leather I had a bit of trouble was cased, and was hard to begin with.  I was a bit surprised that it didn't take too well, but it looks decent now.

Later

 

Edited November 16, 2020 by 1961Mike
misspeled wordz