ToddW Report post Posted September 18, 2021 Is there a punch for a thumb slide for a card wallet? Quote Share this post Link to post Share on other sites
mike02130 Report post Posted September 19, 2021 Ahh, you want the old thumb slide punch, huh? What size thumb? You may want to be more specific. I'm guessing that you want to punch two round holes and cut between them. Quote Share this post Link to post Share on other sites
Arturomex Report post Posted September 19, 2021 (edited) Tandy has the Craftool Pocket Notch Punch. I just use a half round punch and then knock the hard corners off with a knife. 8287eb36d9787909d06209618099f80445be2b31_635x635.webp Edited September 19, 2021 by Arturomex Quote Share this post Link to post Share on other sites
fredk Report post Posted September 19, 2021 A link to the Tandy punch https://www.tandyleather.world/products/pocket-notch-punch I just use an old 3/4 inch circle punch which was damaged and which I ground to a 1/2 circle then I round off the corners (sometimes) with a knife or scissors Quote Share this post Link to post Share on other sites
battlemunky Report post Posted September 19, 2021 If you want a long and wide oblong hole in the middle, I'm sure you could have one made but I just use a half round punch and then connect the punch holes. Quote Share this post Link to post Share on other sites
Squid61 Report post Posted September 19, 2021 Buying an oblong punch for every individual need is way beyond my budget, I just use hollow punches and carefully cut between them. Quote Share this post Link to post Share on other sites
frasheron Report post Posted September 21, 2021 Great information Quote Share this post Link to post Share on other sites
