DavidMillsSaddlery

surely there’s some Landis Guys here?

I kinda gave up on this thing... or put it on the back burner... speaking of which, I’m thinking of pulling a control knob/assembly from a stove and putting it into the place where this adjuster is and see what happens! What’s the worst that could happen? Lol I found a C model, but it’s trapped inside an old boot shop... they rebuilt the storefront and made it a single door... so they can’t get it out of the building!

The motor on mine is 1/2 HP and 1750 RpM’s! Make sure if getting a new one, that the output shaft fits the large pulley properly lubricated, the built in clutch works great! You can feather even thick leather! T

This has a built in clutch in the base... I’m not sure a servo would move this heavy of a flywheel?

Did you get this?

Curious if I’ve got this threaded right? Manual give directions with part numbers... kinda hard to follow?

Where’s it located?

Still available? Photos?

Still open to trades!

Actually $370.00 more...

Price for the whole lot? I have boot clicker dies if interested in trading... 210-831-8764 David

Where at in Mexico? A border town? Or deeper interior?

Then start your own thread...

And I still have a treadle that works fine... to each his own... just because some does something different than you do... doesn’t make them any less than you...

Clutches worked fine for years long before the servo’s showed up...

Well I’ve got an 80 gallon tank in my outside work shop (not inside leather area) and have already run a line into the house to have air pressure available to clean dust and gunk out of machines I’ve recently purchased! So the noise won’t be an issue with me... I was under the impression that the parts for the Boss would also work on these? @CowboyBob yes, I could mount it to my trailer and run it from my truck air supply! I’ve been in contact with this dealer... he’s still in business!

Damn... that’s too bad! The simplicity of it is what I liked! I guess I’ll have to add that to my “wish list”! What’s the story on why they’re no longer in production? No demand? Over priced?

Is this still available/being made? I didn’t see it on their web sight? What do these run? Has anyone had any experience with them? They look stout!

Someone here sent me a manual, and from what I gathered it’s supposed to have an electrical conductive cutting material board that “completes” the circuit? I don’t see that here! They show how to “bypass that” but that doesn’t appear to be done! I found some old dies, and this wouldn’t cut through anything with them! I bought some cheap amazon Chinese made dues and they cut fine? But they’re really small! https://www.kempler.com/inventory/presses/hydraulic-press I’ll call these guys and see if they’ll help, or buy it from me lol

I’m wondering if this isn’t working correctly because I don’t have a “phase converter” on this? That it’s not getting the proper voltage to make it cycle?

Campbell Randall in Texas...

Its very similar to the one I have, and mine ain’t working properly... how much?

You can email the photos to yourself, (via iPhone) and it gives you the option to resize... then open email and save the photos... I see by the area code you’re in California, sonits still early there!

I don’t see any video, photos location or asking price?

Yes, that’s what needs to be done! You need to turn AFTER bottoming out, that way the shuttle has already picked up the thread! When you turn prematurely the thread gets “twisted” and is no longer in the proper position for the shuttle hook to pick it up!