Elliot

I bought them from someone selling His used tools, so don't know. Nice free turning tool, just need a better operator.

I have 2 of those knifes , 5/8 barrels on them. To big for short turns, but nice wide turns.

That tool has not been ground enough. You could spend 40 years with rouge to get a cutting edge. I have 2 or 3 I picked up with other tool sets bought from others. I even bought a new one they are all in the bottom of the junk box. You could wast a lot of time trying to make it work, send it back.

#1 sold pending funds. thank you

With that damage the shaft may be bent. Check that before going further. Good luck

You have a very fix for cramping hands, may not work for everyone. I just tried it feels good in hand, had to slow way up tooling this afternoon. Thank you Rod

I have been told a fully grown Bull, thin places 3/8 in to over 1/2 at the thickest. The wrinkles can be quite deep. takes much work to get hides down to belt thickness, without cutting into the wrinkles. I think 75.00 sq ft is cheep for the work involved. Rod

#3 sold pending funds.

#2 sold pending funds 1 & 3 still for sale

The grid lines are 1 foot apart in the photos Prices per photo shipped flat-rate box lower 48 only Questions PM me 1# 85.00 2# 35.00 3# 85.00 . Below are close-ups. 1 & 3 are dark chocolate

It looks to me that they are to be used in aluminum, or soft metal. You need a sharper thread for steel.

If it was good, Tandy would not be selling at 200. Most of what they sell now make good paper weights or wall hangers. Another good use of Tandy junk, if you have a shop with a front counter leave a few tools scattered around. If they are missing when a so called customer leaves you have them pegged. I use to tear the corner of a 20 (50 would be better now) sticking out from under something fairly light. Some would tell you about it, others try to slip out, the look on their face price-less. Have fun!!!!!!!!!!!

You haven't scratched the surface yet It gets worse.

Will buy one press and both dies. How do you want to get paid? PM me with the details.

I have used MDF for molding, it has to be sealed with resin to keep moisture out. All sides.

PM Sent

AN old Craftool Co. add has it listed as a flower center. It would make a border also.

It is a flower center tool, listed in a Hinckley-Tandy #68 catalog. Don't know the year printed, a while back swivel knives listed for 1.50.

Have a 556 stamp same as L556.. Looks unused, one of the first craftool number systems before letter& #s. PM for more info if what you want.

I have them for 60 and 28?. It doesn't make the blades worse, but not sharper. You should get paid for your time trying to use them.

Bought the pattern, will worth price in the time it will save me. Thank you

What is the address for Pro Edge? Thank you

Use the threaded studs much better and faster to mount.

It is a tool for setting belt snaps.