Search the Community
Showing results for tags 'thread check spring'.
Found 1 result
Hi! New here! I'm hoping someone might share some advice on replacing the paddle spring on my 29-4. I'm about to go nuts trying to figure this out! If I position the needle so that it is fully descended I can see screws that attach the thread check spring to the needle bar. However, these tiny screws are inconveniently halfway covered by the presser foot bar (where it surrounds and swivels around the needle bar) and I cannot reach them. Is there a secret to accessing these screws on the thread check spring? They are so obnoxiously almost accessible so I'm hoping there's an easy fix to this. If you do have to remove the whole needle bar does anyone have any tips? The pivot pin seems to be in their awfully tight and am afraid to really wale on it without some experienced advice. I've attached a photo, i know the quality is poor but home it gets the point across. Thanks! Kelsey